Search results

happy new year. i recived the new ribbon cable, it was a perfect fit. but you have to reuse the black connection pieces as they are one of a kind. i refitted the ribbon cable, messured the wires and all looked ok. mounted the charer in the car. i do no longer have fans spinning up, or the...

yesterday i pulled out the lower plate again and cleaned it for thermal compond. the flex cable itself i have found some burn marks and damage on it, i remeber when assembling the card after soldering, that one pin on the ribbon cable was alitte bendt so i turned the ribbon cable around so the...

in that regard it is pin 29-30 and 33-34 that has some damage on them. i have found that pin 33 is earth pin 34 not in use, cant fin any trace ( in your post its 16V nominal) pin 30 goes to to resistors on the oter side, R552 R764,messures 6,2Mohm and seems to enter IC502 pin 29 i cant see...

it looks to be pin nr 29,30,33 and 34. counted from the right hand side or 17-18, 21-22 counted from the left. due to the board been upside down no i did not think of messuring to the waffleplate. try again tomorrow. if pin 21 i torched, the relay will not have ground to the relay coil, if i...

hmmmmmmmmmmmm after closer look i found F701 to be in order, was some kind of protectic layer i had to remove to be able to messure it

good day goodfolks. so todays attemt was as following i measured the AUX 12V battery to 11,05V. so this i belive is on its way out. for fault finding purposes i connected my 12V dummy charger on the battery. this held the voltage to about 13,5V all day. i use this chargen when coding old...

OK,thanks for tips. i will see if a can arrange a better 12V battery situation, just for elimination sake. never know when a battery comes in handy. scanner says fault 3, but im not sure how relaible that is, i will double check tomorrow. any suggestions on a easy fault to make, to vertify...

hi, and thanks for swift response :) You might have 2 or more separate problems. 1. What is the age and condition of your 12V starter battery. If it is old, weak or worn out then many faults can occur such as failure of the CAN buss communication lines (the Uxxxx codes are related to CAN)...

hi, long story short i bought a MIEV for cheap that does not charge on the granny plug (230V AC) DC/DC charger works, big charging works no problem there. Chademo(?) battery gets 14,4V when car is in "Ready" car run and drives normaly heater, lights and so on OK so i read up on the OBC and...