piev

I guess I don't understand what you are attempting to accomplish. The documentation thus far is very good and we know most of what goes...

PID 149: Rotation = (PID[5] * 256 + PID[4] - 32934) / 32.934; PID 200...

Yes, connect 12v and ground along with CAN-H and CAN-L. when connected to a module the CMU will spit out messages. First byte D1 is...

Not home now but pretty sure those are the formulas I used. Double checked and according to excel my numbers are correct...

Hooked up to a Module and took a data dump Time Stamp ID Extended Dir Bus LEN D1 D2 D3 D4 D5 D6 D7 D8 Column1 Module Temp Temp Temp...

Maybe Piev can share some CAN Buss findings of a single CMU board?

Pretty sure you can do this with the CAN bridge. I know the OBDZero app can monitor the charge profile so the data has to be on the bus...

I did that too but only until I got the BMU to ECU bridge figured out. //Reads all traffic on CAN0 and forwards it to CAN1 (and in the...

Ok, I had to read a little to refresh my mind. So, P1A52 is a cell voltage error from CMU01. There are two ways to spoof this 1) put a...

I already did this because I had a failed CMU board. Not sure if I posted the code. I will look and if I can’t find it on this forum I...

Hello Mike, I made an inquiry and the supplier says these are the original Yuasa Cells. I will attempt to acquire some but minimum...

Sounds like a good idea. I believe you will discover that packaging a battery is harder than finding cells that fit the package...

I will be surprised, they generally only sell to OEMs.

You may be correct. I do know that it has information in it like serial number and model number software version etc. I would have to...