Search results

Mitsubishi i-MiEV Forum

Help Support Mitsubishi i-MiEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Hello there, sorry for long answer Now it's alright, i have normal voltage during charging, I don't know what it was, just kept going charging and once i left charging overnight, charging stoped by itself, and battery was full.i have another interesting issue. As i have an old main battery, car...
  2. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    I am in Florida,here is hot like in hell) So,yeah,it is pretty weird I have a 8 amp charger , i will try to charge somewhere
  3. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Ok,got it.i'll check the voltage in the beginning of charging.yesterday i measured the battery after driving it was near 14,3 V.but ignition was OFF What do you mean extremely low temperature?where?
  4. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Actually yes, recently i have charged main battery, but measured up my auxiliary battery in the end of charging cycle and it was 15,5 volts,I pretty sure that it is too much for it. Frankly,the charge was not finished yet,i decided to complete the charge, since the indlicator showed full. After...
  5. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Hello!It works again!))the water pump starts every 3 minutes and works for 25 seconds.i believe it is normal, isn't it?I haven’t closed the cover yet, it’s quite warm there. thank you very much to everyone who took part in solving this issue,without y'all guys,I wouldn't be able to do it .I’m...
  6. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    understood, thank you. yes, everything is quite clearly visible on your board. I will probably put everything back, change the 12 v battery and try. although there is little hope, I think something happened with the capacitors in the dog house and the unknown condition of the waffle plate...
  7. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    how was the fuse on input AC board?it was intact? how did you check the relay on it?
  8. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Yes , please.i'll try to find them Thanks great!)
  9. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Yes,I measured resistors : 10.2 ohms- relay off and 0.8 ohms -relay on. which diode do you mean and how to measure it?
  10. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    I was thinking about this place too, it looks weird,but i compared it with another photos i had seen.i guess i have the same.probably it is a shadow of gray hermetic
  11. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Apreciate it,Kiev I've checked this fuse first of all before disassembling the OBC.it's ok Good,I will put everything back together, and install a new 12v battery and try. I will write about the result
  12. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    yes, indeed, the 12-volt battery is already dead, now it shows 10.5 volts, although I drove it a one week ago, it should have been at least 11 with something, or even 12. it looks swollen, electrolyte is pouring from the nozzles. It arrived. I'm not surprised,cause the car was parked for a long...
  13. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    the battery is bad, about 30 miles on a full charge, it's about 50% capacity I suppose, I was already planning to do something about it, but here is this charging problem appear unfortunately I didn't scan it, there were no errors on the dashboard, it was a very dump decision , I understand)) I...
  14. Serhiy2192

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Thank you!i checked the resistance between 1 point(near blue capacitors) and each of 4 points N ,it is 10,2 Ω All 3 boards and radio elements seem to be intact. I checked the inductors on the large board, they all have a resistance of about 0.7 Ω,so I think there is no inter-turn shorting, but...
Back
Top