Recent content by Carlossalinas

Mitsubishi i-MiEV Forum

Help Support Mitsubishi i-MiEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. C

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Did you check that 230 VAC arrives inside OBC for at least few seconds after pluging Yazaki charging connector? (Charger and charging power-path is OK) Strange. Old-type batteries have 88 cells x 4,10V = 360,8V, the newer ones have 80 cells x 4,10V = 328V
  2. C

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    Agree. Someone with oscilloscope should measure transient response of the battery voltage when for ex. blower or water pump gets on when charging. Laziness....2x 4R7 ceramic resistors are dead. The pads are accessible only from the waffel plate side of PCB. In advance the inrush current with 4x...
  3. C

    The Troubleshooting and Repair for On-board Charger (OBC) Thread

    [REPAIRED] Hello all, I hope I managed to repair my broken OBC. Many thanks to you guys on this forum. The symptoms were very similar to ChristopheFR's case, so I borrow his post, do some editing to save time and continue my story. My name is Karel, and I am the proud owner of a C-zero in Czech...
Back
Top