This will be a very difficult or impossible repair due to the epoxy. Here are four options to consider, along with thoughts on success. 1, Remove the epoxy of the Junior Waffle Plate (JWP) and replace the transistors. 2. Find a used OBC and swap out the entire JWP. 3. Find a used OBC in a salvage ya...

Okay those links are working. https://ia.wampi.ru/2022/06/20/IMG_20220618_185847.jpg https://ie.wampi.ru/2022/06/22/IMG_20220620_195710.jpg Link to Philsuth's post on page 76 with disassembly photos of this same model OBC. The damaged board here is the PWM Inverter board with the switching transisto...

Good day everyone. I own a mitsubishi i-miev. At one point, it stopped charging, opening the charging module, I saw the following. There are burnt elements on the bottom board under the epoxy compound. There are no services and good electricians in the city. Help determine what elements are worth, ...

Take a look at this link to page 76 of the OBC Troubleshooting thread for the posts by Philsuth about the failure and repair of his 2010 version. Lots of great photos and details of his repair of a capacitor down below the black epoxy, and an xray image of the Junior Waffle Plate. The discussion run...

Marked in red what was faulty, traces of the explosion of elements. I've tried various means to remove the compound, but so far nothing has come of it. I don't know if there will be a label. Help. That black coating is a very hard epoxy covering the circuit board and which makes replacement of part...

Posting a photo for the first time, and in this chat also recently. There's a lot I don't know about this. And maybe I'm asking in the wrong post. I apologize in advance That's not a problem the posts can be moved later if needed. The photo shows that you have an earlier version, pre-2012. We had a...

Здравствуйте, такая же проблема с зарядным блоком zhtp1500r. Не идёт зарядка. Разобрав его увидел сгоревшие элементы на плате. Что делать дальше не знаю помогите советом что можно сделать? Google Translation: Hello, the same problem with the zhtp1500r charger. Not charging. Having disassembled it, ...

To test the diode it would need to be removed from the circuit. On my board i get the same 60 Ohms reading in both directions; this is because the diode is in parallel to the relay coil, so you are just reading the coil resistance. Why do you suspect the diode? If it were shorted then the reading wo...

Sorry too early and not enough coffee yet. How about an intermittent temperature sensor in the cooling loop somewhere? There are 2 cooling fan relays (lo and hi), so it may be that it just went into Hi mode based upon temperature. The temperature sensor is located on the front bottom of the MCU back...

There is not much space in front of the windshield so don't know if it helps or not, the shifter interlock cables (key and brake) are inside the passenger compartment. See diagrams here:
http://mmc-manuals.ru/manuals/i-miev/on ... dex_M1.htm