Hi,
if you have the time and possibility, would you mind letting me know what arduino setup you used? is it a due with two can shields, or a double can bus shield? I tried to find a working solution for the man-in-the-middle can action, but could not find a fully appropriate one.
Best regards.
Hi, so far I have just some first steps in this project - I am currently making infrared floor, door and windscreen heating for those who ordered it from me. So, my progress so far: The EVSE can be turned on by connecting the +12v pin on the EVSE J1772 plug and the ground pin using a resistor...
Great install.
Was it difficult to remove the OEM water pump? I thought that it is one unit with the OEM heater. Is it correct, or it is a separate pump somewhere in the coolant circuit?
Hi,
I found a 4mm diameter little watch on ebay for USD4. It fits perfectly inside the one of the climate control turning knobs.
the process is quite straight forward: after disassembling the knob - which includes removing the panel from the dashboard and clipping off a few plastic clips, the...
Guys,
I started to work on this project. It will be simpler that the factory.
Any type of cabin heater ca be run on 220v ac, when the home charger (j1772) is connected to the car and the battery is already full. You can switch it on remotely - maybe from your phone but not sure yet - and it...