JoeS
Site Moderator
Posts: 3581
Joined: Thu Dec 15, 2011 5:47 am
Location: Los Altos Hills, California

EPA Range Numbers

Sat Nov 10, 2018 10:31 am

Another article desribing EPA's methodology whereby they run a series of very rigorous dynamometer tests and then *arbitrarily* reduce the final range number by 30%. This article didn't discuss how they compensate for different different vehicle aerodynamic characteristics.

https://insideevs.com/ev-range-grain-of-salt/

Here, aero is briefly touched upon:

https://www.fueleconomy.gov/feg/how_tested.shtml

Edit: one of the commenters in the above article posted this:

This is how it works: The car is driven to about 75mph, put in neutral, and allowed to coast on a level road. The speed/distance is measured over time, and using F=ma, you can figure out the force imparted to the car from all sources (air drag, road loss, etc) as a function of speed.
During the efficiency test, the dyno then applies a resistance force to the tire that equals the sum of acceleration force (at the test cycle’s current acceleration) and the force from the above measurements (at the test cycle’s current speed). There’s also a correction to not double-apply any losses (i.e. rolling losses from being on the dyno).
It’s a great test if done right. However, if manufacturers cheat with the data put into the dyno, they’ll get a BS result.
EVs: 2 Wht/Blu SE Prem., '13 Tesla MS85, 3 156v CorbinSparrows (2 Li-ion), 24v EcoScoot(LiFePO4)
EV Conv: 156v '86 Ram PU, 144v '65 Saab 96
Hybrids: 48v1kW bike
ICE: '88 Isuzu Trooper. Mothballed: '67 Saab (orig.owner), '76 MBZ L206D RHD RV

Return to “Driving the iMiev - Range - Energy Efficiency - Operating Cost”