Replacement windshield wiper fluid resevoir cap

[wmcbrine]

I'm having no luck searching for a replacement online, although I figure a broad array of inexact substitutes should work. Temporarily, I'm using duct tape.

[Phximiev]

Perhaps a 3D print: http://www.yeggi.com/q/washer+fluid/?s=tx

[wmcbrine]

Heh, thanks. But to be clear, there's no shortage of caps available online; it's just that, when I check for compatibility, they all say no. The yeggi results don't seem much different in that respect -- no explicit compatibility checker, but no "i-MiEV" mentioned, either.

I was hoping someone could tell me "Yeah, a cap for a BrandX ModelY will work," or "an old film canister lid is a perfect fit." But, I realize I'll probably have to go on that adventure myself...

[wmcbrine]

So, I bought a 3D printer the other day, and I actually did print a wiper cap. Not that any of the existing models were compatible, but I took one and scaled down the diameter. It took a few iterations to get it right, but it's on now:



Until now, I was still using the original duct tape.