my miev do not see the traction battery

Mitsubishi i-MiEV Forum

Help Support Mitsubishi i-MiEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

miev2012JP

New member
Joined
Jun 10, 2019
Messages
1
Good afternoon i-Miev owners! There was such a problem that after the firmware MUT-3 car does not see a traction battery. That is, in the BMU values ​​there are no digits, the battery is essentially "off". I bought the dealer device MUT 3, but how to start the battery I do not know. american car Thanks for the help!
 
miev2012JP, welcome to the forum. Sorry to hear about your troubles.

Could you elaborate a bit more? Presumably the car is completely 'dead'? Do you have any indicators light up when you turn the key? 12v ok? The HV battery safety plug under the seat is in place? North American car (2012?), but you're located where? Perhaps a bit more detail might help us to help you, although very few of us have hands-on experience with that MUT-3.
 
The EV-ECU is the main controller of the car, and it controls all the functions related to the traction battery. A good strong 12V aux battery is needed, since the EVECU drives many relays and contactors after the key is turned ON and to START, in going to READY.

It sounds like the relays are not being energized, but you should use the MUT to read any Diagnostic Trouble Codes stored in the various ECU modules, the troubleshooting steps are determined and based upon the DTCs.
 
Back
Top