kiev wrote:Sorry i did not mean to offend about translation--i had a hard time to understand, but it makes sense that you were on the phone and the reply was somewhat limited.
I am very sorry That I gave you a hard time understanding, the issue was not language related, It is related to my knowledge about this car.
i didn't realize the working car was 2018, it uses a different OBC and MCU than the ones that we have traced the schematics. And likely different control units too, such as EVECU, BMS, etc. The CAN PIDS are different such that the Canion App can't read the cell voltages, so there are many differences between 2012 and 2018 cars.
I noticed, they made lots of improvements. The old car showed 140 km range yesterday, I managed to go 50 with it and still has 70 km range...
With its original computer it showed 110 km...
But my point is that it would seem that the issue is not inside the pack since it went to READY with a different EVECU. Also it would seem that the MCU HV voltage measurement circuit is okay.
The problem came back, so it will be the MCU HV voltage measurement circuit. I think. I hope.
https://forums.drom.ru/attachment.php?a ... 1559710414
So there is this board, I read now carefully, what should I chack and change?
Good luck to you and hope you can find and repair the issue.
Thank you so much for your help!