Hello tout le monde,
Thank you for ansers,
Mea culpa, I publish a corrected version of the relay
test with good connections.
Question : good idea with the resistor, wich value ? and where in series?
On the side of the negative pole of the battery or on the side of the positive pole of the battery?
When I connected the ohmmeter with the white wire, I got OL. So one off the resistors is fused
When I connected the ohmmeter with the black wire, I got 8.5 Mohm . So my ohmmeter works!
Next time, I will realize the relay
if the relay
is ok, that means that I could only change the resistors, right?
My idea: to weld the two new resistors on a small PCB, to fix them together in a little doghouse , and to connect them with big wires to both N of the main PCB (the same place as the first Skylogger’s test)
Advantage: no need to unsolder the waffle
Opinions on my idea? Are the PCB tracks thick enough to support amperage?My problem at this moment : I have not found a seller for Tamura resistor references on Internet? Someone can help me?
Ah, I forgot: I am completely neophyte in electronics! you guessed it?