I would like too perform some tests on this new pack. Do you have any suggestions for future reference ?
I have the following suggestion and you need Canion and an external kWh-meter.
1. Charge to 100% SoC
2. Drive and use energy to get down to at least 20%SoC (maybe down to 10%) - write down Wh-out
3. Charge up to 100% SoC - write down external kWh-meter
value and Wh-reg
4. Calculate Total kWh
((Wh/1000) / (SoC start - SoC end)) for Wh-out
and external kWh-meter
(and get their ratio)
5. Repeat 1-4 until you have a consistent number for Total kWh
for each three measurement methods
6. Repeat 1-5 once for instance every 10 000km
With this tests you will get available kWh
on different points in time.
You will not be able to get total kWh
as this probably only is available by M.U.T. III
By the way - did you get the amp hours value from your dealer?
According to other discussions the dealer should have done this test and you should be able to get this number
This number should be the best reference for future degradations