EVSE blink 2 led

Mitsubishi i-MiEV Forum

Help Support Mitsubishi i-MiEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

krox

New member
Joined
Apr 8, 2019
Messages
4
When the EVSE is plugged in, 2 lights (power and fault) start flashing. Grounding is good. EVSE model: 9482A128.
What could be the reason?
 
Here is a link to a troubleshooting page for the OBC/EV,SE

http://mmc-manuals.ru/manuals/i-miev/online/Service_Manual/2012/54/html/M154950080003200ENG.HTM

Basically they indicate to check the EV,SE device/cable,
or connect MUT to read the OBC codes and run thru the steps for the code.

Blinking Fault (Red) is procedure #8 and is focused on cable and connector issue.
PROBABLE CAUSE:
The charging cable is failed.
Earth leakage of regular charging high voltage system circuits.
Short circuit to earth of pilot signal circuit.
The on board charrger is failed.


Maybe some local EV driver can let you try their EV,SE on your car, or try your EV,SE in their car, to see where the problem resides.
 
Back
Top