Hi
I thought you might be the first to reply, i was considering PMing you.
here is a sample of what i receive, this was with some resistors as temp sensors and a resolver off another motor, I will take a capture of it connected to the correct motor.
0 Receive 01:35:29:094 Data frame Standard frame 00000289 8 27 10 4e 1e 00 00 11 00
1 Receive 01:35:29:094 Data frame Standard frame 00000299 8 14 0d 14 69 13 00 00 00
2 Receive 01:35:29:104 Data frame Standard frame 00000732 8 03 e8 03 e8 64 64 0f 35
3 Receive 01:35:29:104 Data frame Standard frame 00000289 8 27 10 4e 0d 00 00 11 00
4 Receive 01:35:29:114 Data frame Standard frame 00000566 8 00 0a 00 00 00 00 00 00
5 Receive 01:35:29:114 Data frame Standard frame 00000667 8 00 39 34 31 30 41 30 38
6 Receive 01:35:29:124 Data frame Standard frame 00000289 8 27 10 4e 21 00 00 11 00
7 Receive 01:35:29:124 Data frame Standard frame 00000567 8 00 00 00 00 00 00 00 00
8 Receive 01:35:29:124 Data frame Standard frame 00000732 8 03 e8 03 e8 64 64 0e cd
9 Receive 01:35:29:134 Data frame Standard frame 00000289 8 27 10 4e 1c 00 00 11 04
10 Receive 01:35:29:134 Data frame Standard frame 0000056d 8 00 00 00 00 00 00 00 00
I have been told on the outlander forum, the torque requests are on frame 287, what i really need is a full capture.
"Frame 287 would be the PHEV ECU requesting a certain amount of (positive or negative) torque from the front and rear motor, as well as the generator. For example: 2872710271027100000
You see three times 2710. This is hex for 10.000. Subtract 10.000 from this number and divide by 10 to get the Torque requested with one decimal precision. In this case 0.0 for each. Clearly, this frame was captured while parked. First occurrence (A+B) is for front motor. Second occurrence (C+D) is for rear motor, third (E+F) is for generator. Don't know about G and H.
Front motor reports back with actual Torque and RPM via frame 288"
I tried sending some frames to 287 every 100 ms but nothing happens. I Have the DC link powered up at the correct voltage and i think all the connections seem ok, I have RSDN (shutdown) tied low, my wiring for the resolver is not very good, its un shielded untwisted so that could be a problem that i will fix. I am running out of ideas.
Thanks for your help.