Anybody know if you can get round the code mismatch by swapping the main circuit board in the Motor Control Unit when fitting a MCU from another car. Would you have to use the same 3 circuit boards above the IGBTs too?
Told by Mitsubishi engineers in Japan that the Citroen C Zero MCU is stopping the car coming to ready, have swapped it with my imiev's one and sure enough the P1A15 code goes only to be replaced with a code mismatch error.
Taken the circuit boards out and everything looks pristine inside.
Told by Mitsubishi engineers in Japan that the Citroen C Zero MCU is stopping the car coming to ready, have swapped it with my imiev's one and sure enough the P1A15 code goes only to be replaced with a code mismatch error.
Taken the circuit boards out and everything looks pristine inside.